How To Apply The Perfectgrip

STEP1
Holding the club horizontally away from you with the leading edge of the club face pointing straight down and vertically aligned with the shaft, attach the adhesive decal along the center of the shaft approximately and inch below the club's regular grip with the STRAIGHT, FADE and DRAW indicator stripes facing towards the grip.

STEP2 Extract the removable strap from the T-Trac locking system. The Perfect Grip comes with three different straps or varying sizes which allow you to achieve a secure fit by using the strap width that best matches the thickness of your regular grips.

STEP3 Open the Perfect Grip at the butt end by slightly spreading the rails half an inch apart using the thumb and opposing fingers, the press the rails upwards from beneath the clubs so the it fully encircles the shaft below the alignment decal.

STEP4 Continuing to hold the rails apart to reduce friction, slide the Perfect Grip towards you, up and over your regular grip and position the end ring neatly over the butt end of the club. To ensure a firm fit, press the rear of the Perfect Grip hard against the palm of your hand.

STEP5 Check proper attachment by looking down the shaft to ensure the two rails form a straight line with either the STRAIGHT, DRAW or FADE indicator stripes shown on the decal and the leading edge of the clubface when it's vertically aligned.

STEP6 Using your thumb and index finger, squeeze the fore end of the rails together and with the other hand insert the locking strap and pull it towards you by three inches than stop.

STEP7 Transfer the club under your arm with the club head horizontal behind you and the Perfect Grip in front of you. Continue sliding the locking strap close by pushing with your thumb on the raised end, always using your other hand to squeeze the rails together in front of the strap.

STEP8 Now with golf's first fully detachable imprint of a professional grip technique, you can take one of Mark O'Meara's greatest strength and make it your own instantly.